Melt Flow Indexer

XNR-400AM melt flow rate meter is based on GB3682-2000, Test Methods for Determination of ISO1133 thermoplastic flow properties at high temperature instrument, which uses a microcomputer (MCU) control, Chinese user interface, automatic test results; for polyethylene (PE), polypropylene (PP), polyoxymethylene (POM), polystyrene (PS), ABS plastic, polycarbonate melt flow rate measurement (PC), etc. at a high temperature can be measured MFR value (quality Act) 

Testing parameters:

Ø Measuring range :0.1-400.00g/10min(MFR)

Ø Precision of temperature control:  room temperature - 400°c

Ø Precision of temperature:   ±02°c

Ø Precision of timepiece: 1s 

Ø Load:  Full load

Ø Cutting mode: Manual ,by time

Ø Temperature recovery time:  less than 4 minutes

Ø Cut material number :  1-99

Ø Cut material time interval :  10-600 seconds

Ø Holding time:  ten thousand hours of continuous work

Ø Cavity die:    Tungsten carbide, L 8.000mm±0.025mm

               internal diameter Φ2.095mm ±0.005mm

Ø Screw barrel internal diameter:  Φ9.550mm  ± 0.025mm 

Ø Screw barrel length:     152± 0.1mm

Ø Cavity die:  Tungsten carbide, L 8.000mm±0.025mm,  

             internal diameter 2.095mm ±0.005mm

Ø Power:0.45KW

Ø Power supply:  AC220V±10%,50Hz

Ø Dimension: 400mm X 500mm X 600mm

Weight: 60kg