Why do the bottom corners of the model tilt up when I print in 3D?
attention:110 answer:1 offer a reward:0
Away from the problem with
- Unsolveddestoon
- 2021-07-11 22:52
Best answer
No best answer
All the answers
- 1Flooranonymity
- 2021-08-06 14:35
There are two reasons:
1. The bottom layer is not sticky-the leveling is not adjusted properly, the hot bed temperature is not enough, the material quality is not good, and other factors may have an impact.
2. Due to the shrinkage of the material itself, the model cooling fan cannot be turned on when playing abs.
1. The bottom layer is not sticky-the leveling is not adjusted properly, the hot bed temperature is not enough, the material quality is not good, and other factors may have an impact.
2. Due to the shrinkage of the material itself, the model cooling fan cannot be turned on when playing abs.